How to deal with surface defects of titanium plates and rods?
Titanium plate and titanium bar surface reaction layer is the main factor affecting the physical and chemical properties of titanium workpieces, before processing, it is necessary to achieve the complete removal of surface contamination layer and defective layer. So, how to deal with surface defects?
1. Sandblasting:
Titanium wire castings sandblasting treatment generally choose white corundum spray better, sandblasting pressure than non-precious metals is smaller, generally controlled at 0.45MPa below. Because, when the jet pressure is too large, the sand impact on the surface of titanium produces intense sparks, the temperature rise can react with the surface of titanium, the formation of secondary pollution, affecting the surface quality. The time is 15-30 seconds, only to remove the sticky sand on the surface of the casting, the surface sintered layer and part of the oxide layer can be. The rest of the surface reaction layer structure is appropriate to use chemical pickling method to quickly remove.
2. Acid washing:
Acid pickling can quickly and completely remove the surface reaction layer, and the surface will not produce other elements of pollution. HF-HCL system and HF-HNO3 system pickling solution can be used for titanium pickling, but the HF-HCL system pickling solution hydrogen absorption is larger, while the HF-HNO3 system pickling solution absorption of hydrogen is small, you can control the concentration of HNO3 to reduce the absorption of hydrogen, and can be the surface of the brightening treatment, the general concentration of HF in 3% -5% or so, the HNO3 system of brightening treatment, general concentration of HF in 3% -5% or so, the HNO3 system of brightening treatment. The concentration of HF is about 3%-5%, and the concentration of HNO3 is about 15%-30%.
3. Chemical polishing:
Chemical polishing through the metal in the chemical medium of redox reaction and achieve the purpose of levelling and polishing. The advantage is that chemical polishing and metal hardness, polishing area and structure shape has nothing to do, wherever the parts in contact with the polishing solution are polished, without special complex equipment, easy to operate, more suitable for complex structure of titanium denture bracket polishing. But the chemical polishing process parameters are more difficult to control, the requirements of the denture without affecting the precision of the denture can have a good effect on the denture polishing. The better titanium chemical polishing solution is HF and HNO3 prepared in a certain proportion, HF is a reducing agent, can dissolve titanium metal, play a levelling effect, the concentration of <10%, HNO3 plays an oxidising role, preventing titanium from dissolving excessively and absorbing hydrogen, and at the same time, it can produce a bright effect. Titanium polishing solution requires high concentration, low temperature, short polishing time (1 ~ 2min).
4. Electrolytic polishing:
Also known as electrochemical polishing or anodic dissolution polishing, due to the low conductivity of titanium alloy tube, oxidation properties are extremely strong, using aqueous acidic electrolyte such as HF-H3PO4, HF-H2SO4 system electrolyte on titanium almost can not be polished, applying the external voltage, the titanium anode oxidation occurs immediately, and so that the anodic dissolution can not be carried out. However, the use of anhydrous chloride electrolyte at low voltage, titanium has a good polishing effect, small specimens can be obtained mirror polishing, but for complex restorations still can not achieve the purpose of complete polishing.
How to Contact Us
